城市垃圾渗滤液场内循环处理的探讨

本文对城市垃圾渗滤液的产生量、水质特征及其影响因素进行了分析，介绍了当前国内外垃圾渗滤水场内循环处理的两大研究流派-以欧美国家为主的生物反应器填埋技术和以日本为主的循环式准好氧填埋技术。根据我国城市垃圾有机物含量高的特点，提出了适合我国国情的、将准好氧填埋技术与生物反应器填埋技术特点相结合的城市垃圾填埋场渗波液场内循环处理的设计思路。     

气浮--厌氧--生物接触氧化工艺处理屠宰废水

介绍了采用气浮-厌氧-生物接触氧化工艺处理屠宰废水的工程实例。当进水CODcr≤4500mg／L时，出水可达到国家《肉类加工工业污染物排放标准》(GB13457—1992)一级标准。     

Effect of Cross-Linking Waste Protein with Dialdehydes on Its Biodegradation Under Anaerobic Conditions

Most native polymers used in processing and application technologies are admittedly disposable from the environment in a biologic manner, but products possess low mechanical strength. One of the paths to increasing this attribute (if feasible) is their cross-linking, which may, however, affect their readiness to biodegradation. In the presented work this condition was observed on the example of waste protein (Hykol B) cross-linking by means of glutardialdehyde and glyoxal. Degree and course of cross-linking were determined through impedance spectroscopy. The objective of this work also was to obtain data for constructing a sensor capable of following the cross-linking course in real time, for potential industrial application of Hykol in continuous production. Impedance spectroscopy proved to be applicable even to this kind of material marked by considerable water content and exhibiting relatively high electric conductivity; so far it had been used only for materials of low conductivity. An aqueous environment inoculated with digested anaerobic sludge from a municipal wastewater treatment plant was selected for modeling anaerobic conditions. The relation was studied between cross-linking degree given by content of cross-linking agent (determined by impedance spectroscopy) and biodegradation degree under anaerobic conditions. It was confirmed that network density as given by quantity of added agent not only reduced breakdown degree but also slowed the course of the process. This fact is particularly obvious with cross-linking by means of glyoxal; network density is thus dependent on type of employed substance, which affect type and structure of created network. That not merely forms an obstacle during polymer swelling and dissolution but also prevents access of bacteria to source of metabolized organic carbon.     

膜分离技术在水处理中的应用研究

介绍了膜分离技术及其特点，对膜分离技术进行了分类，同时阐述了渗透、电渗析、反渗透、超滤、微滤和纳滤这些常规膜分离技术的研究和应用情况，在此基础上介绍了近年来发展起来的液膜、气态膜、双极膜、膜萃取和膜蒸馏这些新型膜分离技术。提出了膜分离技术存在的一些问题、研究方向、展示了膜分离技术的应用前景。     

有机废气中VOC的回收方法

介绍了炭吸附法、冷凝法和膜分离法回胥机废报中ＶＯＤ的原理、工艺流程和工业应用情况，并对这些方法进行了比较，指出了适用范围。     

厌氧-准好氧型填埋的渗滤液实验研究

通过室内模拟试验，在渗滤液回灌的厌氧填埋柱基本进入稳定状态后，改用准好氧运行方式。同时监测了渗滤液中有机物浓度以压温度、pH值的变化。改变模拟垃圾柱的运行方式两个月以后。氨氯浓度由2000mg／L迅速下降至101．48mg／L，试验结果显示，准好氧运行方式可以解决生物反应器填埋场进入稳定阶段后存在的氨氮浓度高的问题，加速填埋场的稳定。     

两相厌氧工艺的研究进展

为了了解两相厌氧工艺的研究状况,对两相厌氧反应器及相分离方法进行了综述,并指出了今后两相厌氧工艺的研究方向.     

含锌废水处理技术的研究进展

综述了传统的物理化学法和生物法处理含锌废水的原理,系统阐述了其研究进展.微生物固定技术是一种新兴而有效的生物处理技术,尤其是硫酸盐还原菌固定化技术,将厌氧活性污泥包埋,构建稳定高效的微生物体系,以加强其抗毒性和处理效率.因此,在含锌废水处理方面具有很大的发展潜力,有望得到广泛应用.     

液膜分离技术处理含Cr6+废水的研究

采用液膜分离技术处理Cr^6＋质量浓度为200—1000mg／L的废水，考察了膜溶剂、载体、内水相、外水相、pH、乳水比（乳液与废水的体积比）等因素对处理效果的影响，通过正交实验得出最佳实验条件。结果表明，在膜溶剂为煤油、载体为三辛胺、内水相为氯氧化钠、氢氧化钠质量分数为2％、pn为1、乳水比为1：4的最佳条件下，Cr^6＋的去除率可达98．4％。     

CO2资源化利用的现状及前景

介绍了CO2分离捕集最新工艺——电化学法、膜法、化学循环燃烧法的研究进展。评述分析了CO2的各种资源化应用前景：CO2气体用作生物碳源、辅助注射成型剂及有机物（如氨基甲酸酯、表面活性剂）合成原料等；液态CO2用于人造金刚石、热泵干燥、超临界CO2萃取及固体干冰冷喷射清洗等。CO2作为一种潜在的丰富碳源，应不断研发其新的应用领域，加快其工业化应用。